MIL-DTL-8794F
DEPARTMENT OF DEFENSE STANDARDS
MS28741
-
Hose Assembly, Detachable End Fitting, Medium Pressure
(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or
https://assist.daps.dla.mil or from the Standardization Document Order Desk, 700 Robbins Avenue,
Building 4D, Philadelphia, PA 19111-5094.)
2.3 Non-Government publications. The following documents form a part of this document to the
extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
ASTM INTERNATIONAL
ASTM D380
-
Standard Test Methods for Rubber Hose
ASTM D413
-
Standard Test Methods for Rubber Property-Adhesion to Flexible
Substrate
ASTM D471
-
Standard Test Method for Rubber Property-Effect of Liquids
(Copies of these documents are available online at https://www.astm.org or from ASTM International, P.O.
Box C700, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959.)
NCSL INTERNATIONAL
NCSL Z540.1
-
Calibration Laboratories and Measuring and Test Equipment, General
Requirements
(Copies of these documents are available online at https://www.ncsli.org or from NCSL International 2995
Wilderness Place, Suite 107 Boulder, Colorado 80301-5404.)
SAE INTERNATIONAL
SAE ARP603
-
Impulse Testing of Hydraulic Hose Tubing and Fitting Assemblies
SAE AS1933
-
Age Controls for Hose Containing Age-Sensitive Elastomeric Material
SAE J1966
-
Lubricating Oil, Aircraft Piston Engine (Nondispersant Mineral Oil)
(Copies of these documents are available from https://www.sae.org/ or from SAE International, 400
Commonwealth Drive, Warrendale, PA 15096-0001.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein, the text of this document takes precedence. Nothing in this document, however,
supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Qualification. Hose furnished under this specification shall be products that are authorized by
the qualifying activity for listing on the applicable qualified products list before contract award (see 4.5 and
6.3).
3.2 Materials. Hose shall be uniform in quality and free from defects in materials. Materials shall
conform to the requirements specified herein. When a specific material is not called out, a material shall
be used that will meet the performance requirements of this specification.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business