MIL-DTL-26633E
NCLS INTERNATIONAL
NCLS Z540.1
-
Calibration Laboratories and Measuring and Test Equipment
(Copies of these documents are available online at https://www.ncsli.org or from NCSL International,
2995 Wilderness Place, Suite 107 Boulder, Colorado 80301-5404)
SAE INTERNATIONAL
SAE-AMS2700
-
Passivation of Corrosion Resistant Steels
SAE-AS611
-
Hose Assembly and Tubing, Polytetrafluoroethylene, Cleaning
Methods for
SAE-AS1339
-
Hose Assembly, Polytetrafluoroethylene, Metallic Reinforced,
3000 psi, 400 Degrees Lightweight, Hydraulic and Pneumatic
SAE-AS2078
-
Test Methods, Hose Assemblies, Polytetrafluoroethylene (PTFE)
SAE-AS4395
-
Fitting End, Flared Tube Connection, Design Standard
SAE-ARP1153
-
Method for Determining Relative Specific Gravity
Polytetrafluoroethylene Tubing
(Copies of these documents are available online at https://www.sae.org or from the SAE World
Headquarters, 400 Commonwealth Drive, Warrendale, PA 15096-0001.)
2.4 Order of precedence. In event of a conflict between the text of this document and the references
cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Qualification. The hose assemblies furnished under this specification shall be products that are
authorized by the qualifying activity for listing on the applicable qualified products list before contract
3.2 Materials. Materials shall be as specified herein and in referenced specifications and standards
and other referenced documents. Materials not specified shall be selected by the contractor and shall be
subject to all provisions of this specification. Materials shall be free of defects, which adversely affect
performance of the finished product.
3.2.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible, provided that the
material meets or exceeds the operational and maintenance requirements, and promotes economically
advantageous life cycle costs.
3.2.2 Rubber goods. Rubber goods utilized, such as seals, covers, friction layers, etc. shall be
fabricated from rubber components conforming to ASTM D2000.
3.2.3 Other materials. Materials not otherwise specified shall conform to applicable specifications
and to the requirements specified herein. All materials that are not specifically described shall be of the
highest quality and suitable for the purpose intended. There shall be no presence of cadmium, titanium,
magnesium, mercury, or beryllium (see 6.1.4).
3.2.4 Fungus proof materials. Materials that are nutrients for fungi shall not be used where it is
practical to avoid them.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business