MIL-DTL-6000D
NCSL INTERNATIONAL
NCSL Z540.1
-
Calibration Laboratories and Measuring and Test Equipment,
General Requirements.
(Copies of these documents are available online at https://www.ncsli.org or from NCSL International
2995 Wilderness Place, Suite 107 Boulder, Colorado 80301-5404)
SAE INTERNATIONAL
SAE- AMS3002
-
Alcohol, Denatured Ethyl
SAE-ARP6002
-
Marking; Standard Hose, Aircraft
SAE-AS1933
-
Age Controls for Hose Containing Age-Sensitive Elastomeric
Material
SAE-AS5131
-
Tube End - Beaded, Design Standard
SAE-AS5132
-
Fitting End - Hose Connection, Design Standard
(Copies of these documents are available online at https://www.sae.org or from the SAE World
Headquarters, 400 Commonwealth Drive, Warrendale, PA 15096-0001.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein, the text of this document takes precedence. Nothing in this document, however,
supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Qualification. The hose assemblies furnished under this specification shall be products that are
authorized by the qualifying activity for listing on the applicable qualified products list (QPL) before
3.2 Materials. The hose shall be uniform in quality and free from material defects. Materials shall be
as specified herein and shall conform to all applicable specifications. Materials not specified herein shall
be of the best quality and be capable of meeting all of the requirements of this specification.
3.2.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible, provided that the
material meets or exceeds the operational and maintenance requirements, and promotes economically
advantageous life cycle cost.
3.3 Design and construction. The hose shall consist of a seamless compounded inner tube, ply or
plies or reinforcement, and a protective outer coating. The hose end fitting shall be designed in
accordance with SAE-AS5131 or SAE-AS5132 and shall be assembled with hose clamp conforming to
NAS1925. These fittings have a beaded end design and held in place by a hose clamp with the bead end
acting as a mechanical stop. The design shall facilitate servicing, adjustment, or replacement under field
conditions.
3.3.1 Inner tube. The inner tube of the hose shall be manufactured from synthetic rubber
compounded with the necessary ingredients to meet the requirements of this specification. It shall be
seamless and have a minimum thickness of .040 inch (1.02 mm). The bore shall be clean and free from
pitting.
3.3.2 Reinforcement. The reinforcement shall consist of one or more plies with frictioning.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business