MIL-DTL-27267D
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION (ISO)
ISO 17025
-
General requirements for the competence of testing and calibration
laboratories
(Copies of these documents are available email at https://www.ansi.org or from the ANSI Customer
rd
th
Service Department, 25 W. 43 Street, 4 Floor, New York, NY 10036.)
SAE INTERNATIONAL
SAE-ARP1153
-
Determining Relative Specific Gravity Polytetrafluoroethylene
Tubing, Method for
SAE-AS2078
-
Hose Assemblies, Polytetrafluoroethylene (PTFE), Test Methods
SAE-AS1946
-
Hose Assembly, Polytetrafluoroethylene, Metallic Reinforced, Up
to 1500 psi and 450 Degrees F, Hydraulic and Pneumatic
(Copies of these documents are available from SAE International, 400 Commonwealth Drive,
Warrendale, PA 15096-0001, Tel: 877-606-7323 (inside USA and Canada) or 724-776-4970 (outside
USA), https://www.sae.org.)
2.4 Order of precedence. Unless otherwise noted herein or in the contract, in event of a conflict
between the text of this document and the references cited herein the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
3. REQUIREMENTS
3.1 Qualification. The hoses furnished under this specification shall be products that are authorized
by the qualifying activity for listing on the applicable qualified products list before contract award (see 4.4
and 6.3).
3.2 Components. The hose shall consist of a PTFE tube reinforced with a CRES steel wire braid.
3.3 Materials. Materials shall conform to the requirements specified herein. Materials which are not
covered by this specification, or which are not specifically described herein, shall be of the quality
appropriate for the purpose intended. (see 6.1).
3.3.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible, provided that the
material meets or exceeds the operational and maintenance requirements, and promotes economically
advantageous life cycle costs.
3.4 Design and construction.
3.4.1 Tube. The tube shall be a seamless, uniformly gauged extrusion of virgin PTFE resin. The
base resin shall conform to ASTM D4895 except for the specific gravity requirement (see 3.5.2.4).
Additives may be included in the compound from which the tube is extruded.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business