INCH-POUND
MIL-DTL-17505F
7 November 1997
SUPERSEDING
MIL-H-17505E(NAVY)
DETAIL SPECIFICATION
HOSE AND HOSE ASSEMBLY, RUBBER, OIL AND GASOLINE,
SUCTION AND DISCHARGE
This specification is approved for use by all Departments and Agencies of the
Department of Defense.
1. SCOPE
1.1 Scope. This specification covers smooth-bore hose and hose assemblies for suction and
discharge service in the transfer of fuels, such as Navy special fuel oil, diesel fuel, oil, jet fuel
(JP-5 or JP-8), motor gasoline, and aviation gasoline. The hose is intended to handle petroleum
products having an aromatic content no greater than 30 percent. The maximum working pressure
of this hose is 150 pound-force per square inch (psi) (1 034 kilopascal (kPa)).
1.2 Classification. Hose covered by this specification shall be of one type, having a 4-, 6-, 8-, or
12-inch (102, 152, 203, or 305 millimetre (mm)) inside diameter (id), as specified (see 6.2).
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this specification
or recommended for additional information or as examples. While every effort has been made to
ensure the completeness of this list, document users are cautioned that they must meet all
specified requirements documents cited in sections 3 and 4 of this specification, whether or not
they are listed.
Beneficial comments, recommendations, additions, deletions, clarifications, etc. and any data which
may improve this document should be sent to: Commanding Officer (Code 15E2), Naval Construction
Battalion Center, 1000 23rd Avenue, Port Hueneme, CA 93043-4301, by using the Standardization
Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.
AMSC N/A
FSC 4720
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business