A-A-52426 Hose And Hose Assemblies, Non-Metallic, Silicone, Polyester And Wire Reinforced (For Coolant And Heating Systems Of Diesel And Gasoline Powered Engines)This CID covers polyester and wire reinforced, silicone compounded, elastomeric hose and hose assemblies, for coolant and heating systems of diesel and gasoline powered engines, with a temperature range from -40 deg. F to +425 deg. F. All hose types are intended for severe service such as on cars, buses, heavy duty military and commercial trucks, military combat vehicles, and off-road earth moving equipment. Type I (1/2 inch inside diameter (ID) thru 1 1/8 inch ID) hose is intended for connecting hot water heaters to coolant circulating systems of ground vehicles. The hose and hose assemblies described in this CID are hereinafter referred to as "hose".

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15

A-A-52426A

TABLE XIII. Hose length – Continued.

NOTE See 3.2.7 for length of type I and type IV bulk hose.

TABLE XIV. Hose bend angle.

6.4 Supersession data. This CID supersedes MIL-H-62217A (AT), dated 16 January 1981, MIL-H-62217/1A (AT), dated 6 August 1984, MIL-H-62217/2(AT), dated 12 September 1974, and MIL-H-62217/4(AT), dated 12 September 1974.

6.5 Cross-reference. Hose conforming to this CID is substitutable/interchangeable with hose conforming to MIL-H-62217A (AT) as shown in table XV with tables XII, XIII and XIV dash numbers/sizes.

TABLE XV. Sample PIN cross reference.

NOTE: 1/ See 3.2.7.1 and 6.2 to specify type I bulk hose length.

2/ See 3.2.7.2 and 6.2 to specify type IV hose length.

6.6 Regulatory requirements. The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal acquisition Regulation (FAR). The Federal Acquisition Regulation (FAR) may be obtained at the following website: https://www.acquisition.gov/far/.