INCH-POUND
MIL-DTL-17902G(SH)
13 August 2013
SUPERSEDING
MIL-H-17902F(SH)
23 December 1988
DETAIL SPECIFICATION
HOSE, END FITTINGS AND HOSE ASSEMBLIES,
SYNTHETIC RUBBER, AIRCRAFT FUELS
This specification is approved for use by the Naval Sea Systems Command, Department of the Navy, and is
available for use by all Departments and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers both aircraft fuel, synthetic rubber collapsible and noncollapsible hose
assemblies and end fittings.
1.2 Classification.
1.2.1 Part or identifying number (PIN). The military part number for the hose and end fittings covered by this
specification should consist of the letter "M", the basic number of the specification, and the coded numbers or letters
as shown in the following examples:
Hose and Hose Assembly
Hose
M
Specification
Size
Hyphen
Hyphen
Prefix
Number
(Diameter)
Type
Hyphen
Length
M
17902
-
A
-
CCA
-
50
Hose Fitting
M
Specification
Size
Fitting
Hyphen
Hyphen
Prefix
Number
(Diameter)
Type
M
17902
-
A
-
FM
1.2.1.1 Hose, fitting, and hose assembly size. Size should be identified by a letter symbol as shown in table I
(see 6.2).
TABLE I. Size designation.
Symbol
Size (id) (inch)
A
1½
B
2½
Comments, suggestions, or questions on this document should be addressed to: Commander, Naval Sea Systems
Command, ATTN: SEA 05S, 1333 Isaac Hull Avenue, SE, Stop 5160, Washington Navy Yard DC 20376-5160 or
emailed to CommandStandards@navy.mil, with the subject line "Document Comment". Since contact information
can change, you may want to verify the currency of this address information using the ASSIST Online database at
https://assist.dla.mil.
AMSC N/A
FSC 4720
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business