MS8001D
REQUIREMENTS:
Dimensions: Unless otherwise specified, all dimensions are in inches. Fittings: All fittings shall be qualified in accordance with MIL-DTL-27272. Hose: The hose shall be qualified in accordance with MIL-DTL-27267.
Assembly classification: Class 1 and class 2 hose assemblies, as specified in MIL-DTL-25579, have been incorporated into the Part or Identifying Number (PIN) as a part of styles (see tables I and II and figure 1).
Angular alignment: Hose assemblies with elbow fittings on each end shall have the angular orientation between the elbows measured counter-clockwise from the centerline of the nearest fitting, positioned at six-o'clock, to the centerline of the other fitting (see figure 2). The elbow fitting drop height shall be as shown on figure 3 and table IV. When applicable, the angular alignment shall be expressed in three digits and specified in the PIN.
Protective sleeve: If required, the hose assembly shall include a protective sleeve (see table III) and its code shall be included in the PIN.
Assembly length: Hose assembly shall be furnished in lengths as specified in the contract or purchase order (see MIL-DTL-25579); however, tolerances on the length of each hose assembly shall be as follows:
a. ±1/8 inch for lengths under 18 inches.
b. ±1/4 inch for lengths from 18 inches to 36 inches. c. ±1/2 inch for lengths from 36 inches to 50 inches. d. ±1% for lengths over 50 inches.
Flareless fitting, hose connector design: Use MIL-DTL-25579/1 for application of NAS 1760 design.
TABLE IV. Size code and elbow fitting drop height.
Size |
Reference tube OD |
Size code |
Maximum drop height of elbow fitting |
|
(a) 1/ |
(b) 1/ |
|||
3/4 |
0.250 2/ |
B |
0.452 |
0.761 |
4 |
0.250 |
E |
0.444 |
0.745 |
5 |
0.313 |
F |
0.468 |
0.828 |
6 |
0.375 |
G |
0.546 |
0.935 |
8 |
0.500 |
H |
0.642 |
1.072 |
10 |
0.625 |
J |
0.760 |
1.427 |
12 |
0.750 |
K |
0.835 |
1.661 |
16 |
1.000 |
M |
0.889 |
1.811 |
20 |
1.250 |
N |
0.997 |
2.091 |
24 |
1.500 |
P |
1.190 |
2.473 |
1/ Dimensions (a) and (b) are depicted in figure 3.
2/ Size 3/4 hose assembly consists of a size 4 tube OD hose assembled with size 3 tube OD fittings.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business