MS52104D
TABLE I. Hose and fitting thread sizes. 1/ 2/
Designator |
Hose ID ref. |
Hose OD ref. |
Fitting thread ref |
4 |
1/4 inch |
1/2 inch |
7/16 - 20 |
.250 inch |
.500 inch |
||
6.35 mm |
12.70 mm |
||
6 |
3/8 inch |
5/8 inch |
9/16 - 18 |
.375 inch |
.625 inch |
||
9.53 mm |
15.88 mm |
||
8 |
1/2 inch |
3/4 inch |
3/4 - 16 |
.500 inch |
.750 inch |
||
12.70 mm |
19.05 mm |
||
10 |
5/8 inch |
29/32 inch |
7/8 - 14 |
.625 inch |
.906 inch |
||
15.88 mm |
23.01 mm |
||
12 |
3/4 inch |
1 1/32 inch |
1-1/16 - 12 |
.750 inch |
1.031 inch |
||
19.05 mm |
26.19 mm |
1/ Dimensions are in inches
2/ Metric equivalents are for information only.
REQUIREMENTS
Design and configuration: See figure 1 and table I.
Hose material: The hose used in these assemblies shall be in accordance with MIL-DTL-13444, type I. Fitting material and finish shall be in accordance with MIL-DTL-13444.
Fittings: Fitting shall be in accordance with SAE J516 37° flare.
Part or Identifying Number (PIN). The PIN's to be used for hose assemblies acquired to this specification are created as shown in the example below.
MS52104 c 08 016 4
Fractional length in eighths of an inch (0 thru 7).
Length of hose assembly in inches. (Always use 3 digits. Use leading zeros as required.)
Number from table I. Use a leading zero for single digit numbers, i.e. 03 for 3, etc.
Fitting material/finish designator
MS prefix and specification sheet designator
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business