MS52103F
Part or Identifying Number (PIN). The PIN's to be used for hose assemblies acquired to this specification are created as shown in the example below.
MS52103 C -08 016 4 R
Type of fitting. R = Reusable, P = Permanent
Fractional length in eighths of an inch (0 thru 7).
Length of hose assembly in inches. (Always use 3 digits. Use leading zeros as required.)
Dash number from table I. Use a leading zero for single digit numbers, i.e. 03 for 3, etc.
Fitting material/finish designator
MS prefix and specification sheet number
Fitting material/finish designators:
A - Carbon steel, cadmium plated. B - Brass.
C - Carbon steel
S - Corrosion resistant steel. Z - Carbon steel, zinc plated.
Cadmium is not recommended. To the users of this document, it is recommended that the use of carbon steel material with cadmium plating be used only when other materials and finishes specified in this document cannot meet performance requirements.
Some existing MS PIN's do not completely fit the above layout, but they should continue to be used without change.
Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue, due to the extent of the changes.
Referenced document. In addition to MIL-DTL-13444, this document references SAE J516.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business