MS500083E
Part or Identifying Number (PIN). The PIN is to be used for hose assemblies acquired to this specification. Example is shown below:
MS500083 x xx xxx x
Prefix for all PIN's
Fitting material
Dash number from table I. (Do not include
the "dash" . Use a leading zero for single digit dash numbers, ie. 03 for -3, etc.)
Length of hose assembly in inches. (Always use 3 digits. Use leading zeros as required).
Fractional length in eighths of an inch. (0 through 7)
Changes from previous issue: The margins of this specification are marked with asterisks to indicate where changes from the previous issue were made. This was done as a convenience only and the government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue.
Referenced documents. In addition to MIL-DTL-13531, this document references the following:
SAE-J516
CONCLUDING MATERIAL
Custodians: Preparing activity: Army - AT DLA - CC
Navy - SH
Air Force - 99 (Project 4720-2005-010) DLA - CC
Review activities:
Army - AR, AV, CR4, MI Navy - AS, MC, SA,
Air Force - 11, 71
NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https://assist.daps.dla.mil.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business