INCH-POUND
MIL-PRF-28523C
11 September 1997
SUPERSEDING
MIL-H-28523B(NAVY)
9 January 1990
PERFORMANCE SPECIFICATION
HOSE ASSEMBLY, RUBBER, HYDRAULIC AND PNEUMATIC,
JETTING (400 PSI WORKING PRESSURE)
This specification is approved for use by all Departments and Agencies of the
Department of Defense.
1. SCOPE
1.1 Scope. This specification covers rubber hose assemblies for hydraulic and pneumatic jetting
in pile driving, rock drilling, and air compressor use. Hose covered by this specification will be of
one type.
1.2 Classification. Hose covered by this specification will be the inside diameter sizes listed in
3.7 as specified (see 6.2).
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this specification
or recommended for additional information or as examples. While every effort has been made to
ensure the completeness of this list, document users are cautioned that they must meet all
specified requirements documents cited in sections 3 and 4 of this specification, whether or not
they are listed.
Beneficial comments (recommendations, additions, deletions) and any pertinent data which may
be of use in improving this document should be addressed to: Commanding Officer (Code 15E2),
Naval Construction Battalion Center, 1000 23rd Avenue, Port Hueneme, CA 93043-4301, by
using the Standardization Document Improvement Proposal (DD Form 1426) appearing at the
end of this document or by letter.
AMSC N/A
FSC 4720
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business