MIL-DTL-28693 Hose, Rubber, Oil And Gasoline Discharge, Smooth Bore, Lightweight Buoyant Type, Longitudinally Reinforced, 6 InchThis specification covers a hose, rubber, oil and gasoline discharge, smooth bore, lightweight buoyant type, longitudinally reinforced, 6 inch furnished with couplings and a hose support ring. The system is intended for use as part of a buoyant fueling system. The maximum working pressure of this hose is 150psi \(1 MPa\).

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11

MIL-DTL-28693A

2. APPLICABLE DOCUMENTS

2.1 General. The documents listed in this section are specified in sections 3, 4, or 5 of this

specification. This section does not include documents cited in other sections of this specification or

recommended for additional information or as examples. While every effort has been made to ensure

the completeness of this list, document users are cautioned that they must meet all specified

requirements documents cited in sections 3, 4, or 5 of this specification, whether or not they are listed.

2.2 Government documents.

2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and

handbooks form a part of this document to the extent specified herein. Unless otherwise specified, the

issues of these documents are those cited in the solicitation or contract.

FEDERAL STANDARDS

FED-STD-162

Hose, Rubber, Visual Inspection Guide for

FED-STD-601

Rubber, Sampling and Testing

DEPARTMENT OF DEFENSE SPECIFICATION

MIL-C-24356

Coupling, Segmented and Split Clamps, Reattachable, 2-1/2, 4-, 6-,

and 7-inch, for Refueling-at-Sea-Hose

CODE OF FEDERAL REGULATIONS (CFR)

21 CFR 177

Indirect Food Additives: Polymers

(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or

https://assist.daps.dla.mil or from the Standardization Document Order Desk, 700 Robbins Avenue,

Building 4D, Philadelphia, PA 19111-5094.)

2.3 Non-Government publications. The following documents form a part of this document to the

extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the

solicitation or contract.

ASTM INTERNATIONAL

ASTM A153/A153M

Standard Specification for Zinc Coating (Hot-Dip) on Iron and Steel

Hardware

ASTM A572/A572M

Standard Specification for High-Strength Low-Alloy Columbium-

Vanadium Structural Steel

ASTM D297

Standard Test Methods for Rubber Products-Chemical Analysis.

ASTM D380

Standard Test Methods for Rubber Hose

ASTM D381

Standard Test Method for Gum Content in Fuels by Jet Evaporation

ASTM D412

Standard Test Methods for Vulcanized Rubber and Thermoplastic

Rubbers and Thermoplastic Elastomers-Tension

ASTM D413

Standard Test Methods for Rubber Property-Adhesion to Flexible

Substrate

ASTM D471

Standard Test Method for Rubber Property-Effect of Liquids

ASTM D518

Standard Test Method for Rubber Deterioration-Surface Cracking

ASTM D573

Standard Test Method for Rubber-Deterioration in an Air Oven