MIL-DTL-26894D
3.6.2 Length. The length of the hose shall be as specified by the procuring activity (see
6.2) with a tolerance of ±1 percent. Length measurement shall not include the couplings.
3.7 Weight. The weight of the hose shall be not greater than 4 lb/ft.
3.8 Identification of product. The hose shall be legibly marked along its longitudinal axis
with a fuel-resistant yellow stripe. The stripe shall be broken at approximately 2-inch intervals.
3.8.1 Labeling. A label, vulcanized and inlaid approximately in the center on each length
of hose, shall contain the following information:
·
MIL-DTL-26894D
·
Date of Manufacture (quarter and year)
·
Contract or Order No.
·
Manufacturer's Name or Trademark
3.9 Workmanship. The hose assembly shall be uniform in quality and shall be free from
irregularities, defects, or foreign matter which may adversely affect the service performance.
4. VERIFICATION
4.1 Classification of inspection.
The inspection requirements specified herein are
classified as follows:
a. First article inspection (see 4.2)
b. Conformance inspection (see 4.3).
4.2 First article inspection. When specified (see 6.2), samples that are representative of
the production item shall be submitted to the Government after award of a contract for first
article inspection. First article inspection consists of performing all examinations and tests
required in this specification on samples submitted by the manufacturer to determine whether
the production item meets the requirements of this specification.
4.2.1 Samples. Unless otherwise specified, the following samples shall be subjected for
first article inspection as specified in 4.2.2. The samples shall be representative of the
construction, workmanship, components and materials to be used during production. Samples
subjected to destructive testing shall not be submitted as part of the contract or order.
a. a 10-foot length of uncoupled hose
b. a 3-foot length of hose with couplings and caps attached
c. a 15-inch length of hose with couplings attached
4.2.2 Testing of first article. First article inspection shall consist of all the tests specified in
4.4. Rejection and retest criteria shall be as specified in 4.3.2.3.
4.2.3 Test report. Upon completion of the first article inspection, a test report shall be
prepared in accordance with MIL-STD-831 and submitted to the procuring activity. All
applicable inspection reports, recommendations and comments useful in monitoring production
shall be forwarded to the Government quality control representative.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business