MIL-DTL-22706G
2.3 Non-Government publications. The following documents form a part of this
document to the extent specified herein. Unless otherwise specified, the issues of the documents
which are DoD adopted are those listed in the issue of the DoDISS cited in the solicitation.
Unless otherwise specified, the issues of documents not listed in the DoDISS are the issues of the
documents cited in the solicitation (see 6.2).
AMERICAN SOCIETY OF MECHANICAL ENGINEERS (ASME)
ASME - PTC 19.5
-
Interim Supplement on Instruments and Apparatus
Application, Part II of Fluid Meters (DoD Adopted)
(Application for copies of the ASME publication should be addressed to Publications
Department, United Engineering Center, 345 East 47th Street, New York, NY 10017-2392.)
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
ASTM-D413
-
Rubber Property, Adhesion to Flexible Substrate Standard
Test Methods For(DoD Adopted)
ASTM-D629
-
Quantitative Analysis Of Textile Standard Test Methods
For
(DoD Adopted)
(Application for copies should be addressed to the American Society for Testing and
Materials 100 Barr Harbor Drive, Philadelphia, PA 19103.)
2.4 Order of precedence. In the event of a conflict between the text of this document and
the references cited herein, the text of this document takes precedence. Nothing in this document,
however, supersedes applicable laws and regulations unless a specific exemption has been
obtained.
3. REQUIREMENTS
3.1 Qualification. The items furnished under this specification shall be products which
are authorized by the qualifying activity for listing on the applicable qualified products list
before contract award (see 4.2 and 6.3).
3.1.1 Qualify by similarity. If approved by the contracting activity, qualification shall be
granted to the Class II duct or scuff cover if the manufacturer is qualified to the Class I duct and
scuff cover and the design, construction, and materials of the Class I duct and scuff cover and the
Class II duct and scuff cover are the same.
3.2 Materials. Materials selected for construction of duct and scuff cover shall be of
uniform quality and free of defects that may adversely affect the appearance, strength, endurance,
and wear resistance of the finished products. The materials used shall be resistant to
environmental deterioration such as temperature and humidity, corrosion, liquid absorption, or
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business