INCH-POUND
A-A-52435A
3 August 2009
SUPERSEDING
A-A-52435
2 April 1993
COMMERCIAL ITEM DESCRIPTION
HOSE ASSEMBLIES, METAL: FLEXIBLE,
FUEL AND OIL
The General Services Administration has authorized the use of this commercial item
description (CID) as a replacement for MIL-H-13524B(AT), which is cancelled.
1. SCOPE. This CID covers two types of flexible hose assemblies for the conveyance of
gasoline or oil or for other applications when installed in military vehicles or other U.S. Army
equipment with the exception of use with aircraft engine fluid lines.
1.1 Classification. Hose assemblies shall be of the following types as specified (see 5.2):
Type I - Corrosion resistant steel
Type II - Bronze or brass
2. SALIENT CHARACTERISTICS
2.1 Materials. Materials used in the hose assemblies shall be as specified herein and in
applicable drawings (see 5.2). The use of recovered materials made in compliance with
regulatory requirements is acceptable providing all requirements of this CID are met (see 5.5).
2.2 Design and construction. Hose shall consist of corrugated or convoluted tubing of seamless,
welded, or brazed design, protected with a cover of one or more beamed wire braids. Each
length of hose shall be fitted with a set of couplings, as specified in applicable drawings (see
5.2), each permanently attached to hose.
Comments, suggestions, or questions on this document should be addressed to U.S. Army
Tank-automotive and Armaments Command, ATTN: RDTA-EN/STND/TRANS, MS# 268,
6501 E. 11 Mile Road, Warren, MI 48397-5000 or emailed to
DAMI_STANDARDIZATION@conus.army.mil. Since contact information can change, you
may want to verify the currency of this address information using the ASSIST Online database at
https://assist.daps.dla.mil.
AMSC N/A
FSC 4720
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business