MIL-DTL-81581-5 Hose Assemblies, Breathing Oxygen, Low Pressure, Connector To RegulatorThis specification sheet covers the detail requirements for three types and four styles of low pressure oxygen breathing hose assemblies from connector to regulator, with or without integrated services for communication continuity.

Pages 1 - 2 - 3 - 4 - 5 - 6

INCH-POUND

MIL-DTL-81581/5B

24 July 2006

SUPERSEDING

MIL-H-81581/5A

10 December 1982

DETAIL SPECIFICATION SHEET

HOSE ASSEMBLIES, BREATHING OXYGEN, LOW PRESSURE,

CONNECTOR TO REGULATOR

Reactivated after 24 July 2006 and may be used for new and existing designs and

acquisitions.

This specification is approved for use by all Departments and Agencies of the Department

of Defense.

The complete requirements for acquiring the hose assemblies described herein shall consist

of this specification sheet and MIL-DTL-81581.

SCOPE

1.1 Scope. This specification sheet covers the detail requirements for three types and four

styles of low pressure oxygen breathing hose assemblies from connector to regulator, with or

without integrated services for communication continuity.

1.2 Classification. Hose and hose assemblies covered by this specification sheet shall be of

the following types and styles, as designated by the applicable MS number, as specified (see

6.2):

1.2.1 Types. The types of hose assemblies are as follows:

Type I

Hose assembly without integrated communication cable

and without connector

Comments, suggestions, or questions on this document should be addressed to: Commander,

Naval Air Warfare Center Aircraft Division, Code 491000B120-3, Highway 547, Lakehurst, NJ

08733-5100 or emailed to thomas.omara@navy.mil. Since contact information can change,

you may want to verify the currency of this address information using the ASSIST Online

AMSC N/A

FSC 4720