MIL-DTL-26894D
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION
ISO4649
-
Rubber - Determination of Abrasion Resistance Using a
Rotating Cylindrical Drum Device
(Request for copies should be addressed to International Organization for Standardization,
Case Postale 56, Geneva, Switzerland CH-1211.)
SOCIETY OF AUTOMOTIVE ENGINEERS (SAE)
AS1933
-
Age Controls for Hose Containing Age-Sensitive Elastomeric
Material (DoD adopted)
(Application for copies should be addressed to the Society of Automotive Engineers, 400
Commonwealth Drive, Warrendale, PA 15096-6001.)
2.4 Order of precedence. In the event of a conflict between the text of this document and
the references cited herein (except for related associated specifications, specification sheets,
or MS standards), the text of this document takes precedence. Nothing in this document,
however, supersedes applicable laws and regulations unless a specific exemption has been
obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), samples shall be submitted for first article
inspection in accordance with 4.2.
3.2 Material. Materials shall be as required in this specification and shall conform to all
applicable Government specifications and drawings, except as otherwise specified herein.
Materials which are not covered by specifications, or which are not specifically described
herein, shall be of the quality appropriate for the purpose intended (see 6.1).
3.2.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered,
or environmentally preferable materials should be used to the maximum extent possible
provided that the material meets operational and maintenance requirements, and promotes
economically advantageous life cycle costs.
3.3 Design and construction. Unless otherwise specified in the contract or in the
purchase order (see 6.2), the hose shall consist of the following components:
a.
a compounded inner tube (see 3.3.1.1)
b.
braided, loomed or plied-type reinforcement (see 3.3.1.2)
c.
a helix wire (see 3.3.1.3)
d.
a compounded cover (see 3.3.1.4)
3.3.1 Hose. The hose shall be no more than eight quarters old from the cure date to the
date of delivery to the procuring activity or to the manufacturers of hose couplers and other
accessory equipment. The hose assembly installed in equipment shall be no more than
sixteen quarters old upon the date of delivery of that equipment to the procuring activity. The
cut hose ends shall be sealed with a sealant or cement. Definitions for "cure date" and
"quarter" can be found in AS1933.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business