MIL-DTL-3992F
NCSL INTERNATIONAL
NCSL Z540.1
-
Calibration Laboratories and Measuring and Test Equipment,
General Requirements
(Copies of these documents are available online at https://www.ncsli.org or from NCSL International
2995 Wilderness Place, Suite 107 Boulder, Colorado 80301-5404)
SAE INTERNATIONAL
SAE-J1402
-
Automotive Air Brake Hose and Hose Assemblies
SAE-J1403
-
Vacuum Brake Hose
SAE-AMS-QQ-P-416
-
Plating, Cadmium (Electrodeposited)
(Copies of these documents are available online at https://www.sae.org or from the SAE World
Headquarters, 400 Commonwealth Drive, Warrendale, PA 15096-0001.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein (except for related specification sheets), the text of this document takes
precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
3. REQUIREMENTS
3.1 Specification sheets. The individual item requirements shall be as specified herein and in
accordance with the applicable specification sheet. In the event of any conflict between requirements of
this specification and the specification sheets, the latter shall govern.
3.2 Qualification and first article inspection.
3.2.1 Qualification inspection. Type I hose and hose assemblies furnished under this specification
shall be manufactured and assembled by a qualified manufacturer and/or assembled by a qualified
assembling distributor and shall be a product which has been tested and has passed the qualification
tests specified herein and has been listed on or approved for listing on the applicable qualified products
list (QPL) before contract award (see 4.3 and 6.3). Hose assemblies shall be qualified as a combination
of hose and fittings from specific sources. Any subsequent change to either the hose or fitting source in a
qualified assembly requires documented approval of the qualifying activity.
3.2.2 First article inspection. Type II hose and hose assemblies shall be subjected to first article
inspection. Hose assemblies shall be tested as a combination of hose and fittings from specific sources.
Any subsequent change to either the hose or fitting source in an approved assembly requires
documented approval of the procuring activity.
3.3 Critical interface materials. Materials shall be as specified herein and in reference specifications,
standards, drawings, or recognized industry equivalent standards. If materials other than those specified
are used, the contractor shall certify to the preparing activity that the substitute material(s) enables the
hose or hose assemblies to meet the performance requirements of this specification. Acceptance of any
constituent materials shall not be construed as a guaranty of the acceptance of the product. When a
definite material is not specified, a material shall be used which shall enable the hose or hose assembly
to meet the performance requirements of this specification.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business